Hello Guest it is March 29, 2024, 11:29:08 AM

Author Topic: Not going till the end of line  (Read 3776 times)

0 Members and 1 Guest are viewing this topic.

Offline viz

*
  •  17 17
    • View Profile
Not going till the end of line
« on: December 11, 2013, 05:27:07 AM »
Hello,

As always some problems and don't understand why so simple things can't be done easy way.

The spindle gets into to the material and goes straight till the end of the line, but before the end of line the spindle goes up. The feed rate is 2600mm/min, also tried with slower ~1300mm/min, but the result is the same. So after first cut i have to rotate the material 180 degree and cut again to get the same results in both ends. 

I have attached my .dxf and .nc files (nc was written with Aspire)

Offline Tweakie.CNC

*
  • *
  •  9,196 9,196
  • Super Kitty
    • View Profile
Re: Not going till the end of line
« Reply #1 on: December 11, 2013, 07:11:47 AM »
Viz,

Try running the code in Exact Stop motion mode (config / general config).

Tweakie.
PEACE