Hello Guest it is May 24, 2025, 07:23:40 PM
Profile Guest
« previous next »
Pages: « 1 2   Go Down

Author Topic: Manual Tool Change with TTS  (Read 9498 times)

0 Members and 1 Guest are viewing this topic.

Offline HimyKabibble

*
  • 1,687 1,687
Re: Manual Tool Change with TTS
« Reply #10 on: November 06, 2013, 11:34:31 AM »
The M6 and G43 lines in the first code are commented out (";" indicates a comment, and the rest of that line is compleletely ignored by Mach3), so not executed!

Regards,
Ray L.
Logged
Regards,
Ray L.

Offline wwholden

*
  • 12 12
Re: Manual Tool Change with TTS
« Reply #11 on: November 06, 2013, 11:36:13 AM »
I figured it out. Its the post processor for BobCAD Im using. Its commenting out or block deleting anything that as to do with tool data. I switched from the post that says NO ATC to just a plain Mach3 Rev1 post. Now the lines are being read by the control. Wonderful! :)
Logged

Offline BR549

*
  • 6,965 6,965
Re: Manual Tool Change with TTS
« Reply #12 on: November 06, 2013, 11:36:54 AM »
THose " ; "should not be there.

(;-) TP
Logged
Pages: « 1 2   Go Up
« previous next »