I need to make some cams, for a project, and did the code in BobCAM-CAM, ver 24. using their 4th Axis Wrapping. The code looks fine, when you verify it, in BobCAD, but when I try to run it using Mach3, on a Taig 4 axis mill, the feed very move, with Feed set at 30 in/min.
This is the frist time I have used the 4th Axis.
Code
G90 G54 X.5837 Y 0.
G01 Z.4151 F 4.843
X.3279 A186.382 F30.0
First two lines work fine, but X,A line, motor moves very slowly.
If I do the X, and A on different lines speed is good, but can not cut the part, that way.
Does any one have any idea of what is wrong?
Ken K