I have found a number of 'simple' tool setting scripts, but I would like to have one that after Z initially touches the sensor, it retracts a small amount and contacts the sensor again a little slower. By doing this it is taking out any over run of the spindle. I would also like to know how difficult it would be to write in the script to have the Z offset display not only the height of the sensor, but also the retract amount. Lets say that I am using a sensor that is 1.00 tall and I have a retract amount of .25, I would like to see the Z offset read
Z 1.25. Any input would be appreciated.
Thanks, Jim