Author Topic: Unwanted Circles on New Compute/new Mach Install  (Read 1544 times)

0 Members and 1 Guest are viewing this topic.

Offline dneisler

  • Active Member
  • Posts: 8
    • View Profile
Unwanted Circles on New Compute/new Mach Install
« on: August 12, 2013, 08:26:11 PM »
I just traded in my old computer for a newer one, and reinstalled Mach3 and MachStdMill and tried to run a part I have ran before without issue. I get MANY unwanted circles.... I am sure it is a config issue, but I have no clue what. It was drawn in Soldiworks, and the Gcode posted from HSMworks. I reposted the code, and same issue.

Any suggestions?

Offline ger21

  • Global Moderator
  • *
  • Posts: 6,156
    • View Profile
    • The CNC Woodworker
Re: Unwanted Circles on New Compute/new Mach Install
« Reply #1 on: August 12, 2013, 08:54:01 PM »
Change your IJ mode in General Config.
Gerry

2010 Screenset
http://www.thecncwoodworker.com/2010.html

JointCAM Dovetail and Box Joint software
http://www.g-forcecnc.com/jointcam.html

Offline Hood

  • Mach4 Alpha
  • Posts: 25,775
  • Carnoustie, Scotland
    • View Profile
Re: Unwanted Circles on New Compute/new Mach Install
« Reply #2 on: August 13, 2013, 02:55:14 AM »
Better still, have a G90.1 or G91.1 in all of your code to tell Mach which mode a particular file is using.
Hood