Ian I went back and tested the buffer loading and something has changed since I work on probing years ago. The G31 is now  NOT loading into the buffer. You can check the buffer load and Que in diagnostics.

Years ago it DID load the buffer, Just love those undocumented changes.

(;-) TP

AH but it does . When you call a G31 X10 the planner plans  to go to X10 . When the trip is done it is an "interupt" signaling mach to go to the next line.

Ah but the key word you used that I'm questioning is not PLANNER - it's LOOKAHEAD.

Ian

I believe the look ahead is basically for the CV component yes?. IF the planner loads code into the buffer then Look ahead can see it and use it if possible. IF the code is only loaded one line at a time into the buffer then look ahead is NOT possible.

(;-) TP

I believe the look ahead is basically for the CV component yes?.

Exactamundo

IF the planner loads code into the buffer then Look ahead can see it and use it if possible. IF the code is only loaded one line at a time into the buffer then look ahead is NOT possible.

Buffer, schmuffer  You can't CV (blend) into or out of a G31 - it's just plain silly.

Ian

Thank you stirling, I will try to use that command and see if it works