Hello Guest it is March 29, 2024, 03:43:21 AM

Author Topic: NFS face lift...  (Read 6380 times)

0 Members and 1 Guest are viewing this topic.

NFS face lift...
« on: February 13, 2007, 11:16:51 PM »
Hello all.
As you all know I work on Mach3 and Lcam (as I have time). But what you may not know is that I started by making addons for mach2! Yes mach2 the program that I will not run... But after that I did the NFS conversational set and started selling them (in Mach3). it has been about 1.5 years and I have not added any new stuff to the wizard set :( But that is about to change as Ron Ginger is picking up where I left off (brave man). Ron is a very good programmer and is adding some VERY cool toys.

Please check out this link:

http://www.machsupport.com/forum/index.php?topic=2423.10

I think Ron is going to make it so even if you don't know CNC you will want one just because it is a smart 3 axis power feed ;)

So thank you Ron and keep up the great work!

Brian
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com
Re: NFS face lift...
« Reply #1 on: February 16, 2007, 09:18:05 PM »
Also see http://www.machsupport.com/forum/index.php?topic=2468.0 for a new release of the Newfangled set.

ron ginger