Hello Guest it is March 28, 2024, 08:36:17 AM

Author Topic: HELP !!!! What Do I Need??  (Read 5969 times)

0 Members and 1 Guest are viewing this topic.

Re: HELP !!!! What Do I Need??
« Reply #10 on: April 10, 2013, 09:22:57 AM »
Thank you garyhlucas and jonny quest :) The MadCAM video is almost exactly what I will be doing. I have looked at Rhino3D before, but may need to take another closer look. The amount of software that is out there is totally amazing and mind boggling.

Again, Thank You everyone :)
Man who say it cannot be done should not interrupt woman doing it - Confucius
Re: HELP !!!! What Do I Need??
« Reply #11 on: April 11, 2013, 10:40:19 AM »
Someone mentioned custom mills for the groove. I am in the process of buying ready made from Italy.
Man who say it cannot be done should not interrupt woman doing it - Confucius
Re: HELP !!!! What Do I Need??
« Reply #12 on: April 11, 2013, 10:20:20 PM »
That was me,
However if the specials you need are already available they will likely be much cheaper.  I used Rhino for 6 years, and now have 6 years with Solid Edge, and likely to be changing to Solid Works.  The changes are only because of job changes, they are all very good software in their own ways.

Gary H. Lucas