OK, i checked out what information i could find and at the moment i'm at a total loss with confusingness
I've got the offset figured out, it makes little loops but i'm sure i just need to make some small adjustments as i read it's a mach3 issue?
I still haven't worked out how to get multipass figured so instead of annoying everyone i tried to work around it, i tried
Mirroring so i could get another object mirrored next to the original, saving me 3000 lines of code each time i did this, that failed. The best i could do was the x-y moved to the lcation then moved back to where the next command said.
Sub-routine, i figured if i could make this work i would call the sub-routine and specify various depths saving me around 2000 lines per item, but i'd have to manually change the x-y.
Any help would be appreciated, i've attached the g-code and i will admit i'm not a professional, but i would like it to go down in 3 step increments 2MM then be able to make it so it is capable of doing the same next to/underneath the programmed one