In the Mach3 general logic configuration screen a checkbox is present to "allow wav files"   also, "allow speech"

I have an application that could benefit from playing .wav files for at different times during a part program.  Is that the intent of these functions?  Is there any documentation on these?

Yes and YES, Mach3 programers guide.

(;-) TP

OK, so how does "allow wave files" in the setup tie into the sub playwave ?  Playwave does not function without the box checked?

Is "allow speech" something else?

Turn on the allow wave and allow speach.

From a Mcode  add in the code you want to do.

Playwave plays a Soundfile that you define

Speak uses the window speak function to say the words you defined in the call.

It is in the Mach3 macro programmers manual.

(;-) TP

Thank you sir.

could you give more info not sure how to do this

http://www.machsupport.com/docs/Mach3_V3.x_Macro_Prog_Ref.pdf

Page 93

i have seen all of that stuff but how do i put it into a macro, tool change macro, end of program macro and fault macro

I would go to the video section of this website and watch the one on macros.

First you start off learning simple CB programming then you expand your skills and modify your running macros.

Just a thought, (;-) TP