Hi There,

I have bought a servo system (DMM tech) I am now in a process of learning how to set this up. Here is my problem:

I have bought oversized motors, so I can direct drive the mill. I am trying to work out the steps per value, I have been told to use the value of 2000 as my ballscrew is 5mm pitch and 1:1 ratio this seems right to me. However this seems to limit the mill to 750mm/m do I need to modify the kernal speed or is there another way to get higher speeds? The encoder is a 14bit enconder, any help would be appriciated as I would like to understand how to set these values and the DMM documentation is of little help in this area.

Thanks,

Andy