Hello Guest it is April 19, 2024, 05:11:23 PM
Profile Guest
« previous next »
Pages: « 1 2 3 4   Go Down

Author Topic: Mach to DeskCNC?  (Read 21435 times)

0 Members and 1 Guest are viewing this topic.

Offline Brian Barker

*
  • *
  • 3,859 3,859
    • View Profile
Re: Mach to DeskCNC?
« Reply #30 on: February 06, 2007, 04:52:54 PM »
Change the time length of the moves. If you send longer moves I think it will fix your problem
Logged
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com

Offline Greolt

*
  • 956 956
    • View Profile
Re: Mach to DeskCNC?
« Reply #31 on: February 06, 2007, 05:43:28 PM »
Brian

Do you mean "Servo Cycle Time"  ?

If so, then you are saying to set it to .00177 instead of .00084   Is this correct ?

Greg
Logged

Offline Brian Barker

*
  • *
  • 3,859 3,859
    • View Profile
Re: Mach to DeskCNC?
« Reply #32 on: February 06, 2007, 05:54:25 PM »
Yup that should help...
Logged
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com
Pages: « 1 2 3 4   Go Up
« previous next »