Hello Guest it is November 22, 2019, 02:08:57 AM

Author Topic: Labview programs to control CNC motors  (Read 5401 times)

0 Members and 1 Guest are viewing this topic.

Labview programs to control CNC motors
« on: October 17, 2012, 10:53:04 AM »
Hi everyone,

I bought a 3 Axis Electronics Combo from CNC; and I used Mach3 to control all these motors. But there is a problem recently that we need to use Labview program from National Instruments to control them instead of Mach3. Is there someone who has experience about using Labview programs to control these motors or has any suggestions about how to integrate Mach3 program into Labview?

Many thanks.
Re: Labview programs to control CNC motors
« Reply #1 on: October 13, 2014, 01:20:04 PM »
Hey Feder,

Did you find any help ! I am also trying to solve a similar problem.

I have multiple sections in my system being controlled by labview. I have to introduce 3 axis motion control into the system and I am planning to use Mach3 for this. It would be great if I can integrate/call Mach3 in labview so that I have only one front panel for the system.

I am using a TB6560 driver board.