Hello Guest it is November 21, 2019, 11:32:34 PM

Author Topic: Setting up Problem  (Read 3305 times)

0 Members and 1 Guest are viewing this topic.

Offline Tweakie.CNC

*
  • *
  •  8,008 8,008
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: Setting up Problem
« Reply #10 on: October 08, 2012, 10:10:18 AM »
Download and run Parmon http://www.geekhideout.com/parmon.shtml

This will test if your parallel port is operating correctly.

Tweakie.
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.
Re: Setting up Problem
« Reply #11 on: October 17, 2012, 04:36:02 AM »
Thanks Tweakie, the parmon is very handy in deed.

Solved my problem....
Wrong pin assignment, Step as Dir, & vice verse... & never restart Mach after setting pin numbers...
Embarrassing...

Offline Tweakie.CNC

*
  • *
  •  8,008 8,008
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: Setting up Problem
« Reply #12 on: October 17, 2012, 05:05:56 AM »
That's good, I am pleased to hear that you are now on your way.

Tweakie.
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.