Hello Guest it is December 08, 2021, 04:55:18 PM

Author Topic: Auto Setup of Inputs  (Read 1614 times)

0 Members and 1 Guest are viewing this topic.

Offline kolias

  •  1,011 1,011
    • View Profile
Auto Setup of Inputs
« on: September 12, 2012, 09:11:30 AM »
I just wonder why the “Automated Setup of Inputs” in Mach3 does not recognize my Auto Zero Z axis Plate but I was able to setup all my limits with it.

When I set it up manually I choose Probe, Enable, Port 1, Pin 13, Active Low, and it works but if I choose the Automated Setup of inputs and I close the switch manually, Mach3 does not see that the switch is closed and therefore does not assign a pin number