Setting up a 3 axis router w/ a DMC-2143. Everything works fine until I engage softlimits, the X and Y travel is about 10' by 5', so I entered X 0 to 120, Y 0 to 60, Z 0 to -15. Home the machine fine, engage softlimits, the Z softlimits work fine, the machine refuses to move in either the X or Y direction. If I jog the machine out to the middle of the table and then engage softlimits, it will jog towards 0,0 no matter which jog direction I attempt... Then it gets to zero and there it stays.
I have X and Y "reversed" in the softlimits dialog, is this related? I tried entering X -120 to 0, but that's a no go either...
Thanks for any help...