Hello Guest it is November 12, 2019, 08:49:29 AM

Author Topic: help with bob  (Read 1149 times)

0 Members and 1 Guest are viewing this topic.

help with bob
« on: August 18, 2012, 03:30:14 PM »
I just purchased a BOB from cnc4pc (C 11) I plugged the cable into my ethernet smoothstepper, installed the power to the board and ran a wire to try it out using a metal plate for auto zero. I went to ports and pins and set probe to port three pin 15, and tried the auto zero led, into which I had already loaded an auto zero macro that someone was kind enough to post. The macro ran flawlessly but it dosn't seem to see the board. I checked the smoothstepper configuration and it shows all three ports working. What am I missing? I would appreciate any suggestions. :'(