Hello Guest it is September 17, 2019, 07:33:05 AM

Author Topic: X axis consistently off on one toolpath  (Read 982 times)

0 Members and 1 Guest are viewing this topic.

X axis consistently off on one toolpath
« on: November 24, 2015, 04:23:25 PM »
Hi all.

I have a quick question.

I have a particular guitar fretboard toolpath I have been working on and whenever the CNC cuts it out, I have one axis consistently off by about 1/32"
Now here is the part that I don't understand: On one side of the fretboard, it is 1/32" too small. On the other side, it is fine.

What would this mean? I don't think that would be lost steps because it always shows up on the one side of the guitar fretboard.
I have checked and rechecked my toolpath and it SHOULD cut the fretboard perfectly equal on both sides.


Any ideas what is going on?

Online RICH

*
  • *
  •  7,358 7,358
    • View Profile
Re: X axis consistently off on one toolpath
« Reply #1 on: November 24, 2015, 07:14:54 PM »
Post the gcode and maybe someone will have a look.
If it's not hand coded then post the dxf file the gode was based on.

RICH