Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: AlexanderJamesGuitars on November 24, 2015, 04:23:25 PM
-
Hi all.
I have a quick question.
I have a particular guitar fretboard toolpath I have been working on and whenever the CNC cuts it out, I have one axis consistently off by about 1/32"
Now here is the part that I don't understand: On one side of the fretboard, it is 1/32" too small. On the other side, it is fine.
What would this mean? I don't think that would be lost steps because it always shows up on the one side of the guitar fretboard.
I have checked and rechecked my toolpath and it SHOULD cut the fretboard perfectly equal on both sides.
Any ideas what is going on?
-
Post the gcode and maybe someone will have a look.
If it's not hand coded then post the dxf file the gode was based on.
RICH