I would be suprised if this hasn't been asked before but its difficult to narrow it down in search due to how popular this site is!
I have a Denford Triac with 6 position carousel ATC but have a lot more toolholders than spaces in the ATC.
Can I give each toolholder a number (T1, T2 ...T30 etc) and then assign a seperate slot number in the ATC where it is located, and what would a line of VB look like to represent this, or am I limited to give the slot number the T value?
By having as many T numbers as I have toolholders (30+) will be great as I only need set the offsets and diameters once. If not it would mean setting up each toolholder for every program I ran.
thanks ...Sweep