Hello Guest it is March 23, 2023, 08:30:24 PM

Author Topic: Jerky  (Read 1624 times)

0 Members and 1 Guest are viewing this topic.

« on: October 20, 2014, 09:04:36 AM »
I just got done upgrading my machine leadscrews. When carving lettering, specifically in the curves, my machice seems to be very jerky. When it's on straight lines on the X or Y, it's smooth. I was told on another forum that I should be running my Accel at less than the Velocity. Right now it's set at 50 on the Velocity and 10 on the Accel. Before the upgrades, I used to run the Accel higher than the Velocity and seemed to be much smoother. What should I do? I am running Vcarve pro and Mach3.
Thank's Mike
Mike Kearns
Re: Jerky
« Reply #1 on: October 20, 2014, 09:40:13 AM »
I misstated when I said That I ran the Accel Higher. Actually I ran the Accel at 30 and the Velocity at 35. I guess I'll go mess with it. Maybe I've got too much of a spread between the two right now.
Mike Kearns