Hello Guest it is December 01, 2021, 10:40:39 AM

Author Topic: Homing issue with slaved axis  (Read 1706 times)

0 Members and 1 Guest are viewing this topic.

Homing issue with slaved axis
« on: June 04, 2012, 01:09:27 AM »
I'm trying to square the gantry but I'm having an issue.  I have the A axis slaved with the X axis, but when I leave the checkbox unchecked that says "home slave with master axis" the slaved axis (A) does not move at the same rate of the X axis.  it moves slower causing the gantry to twist.  Jogging is no problem.  This problem only seems to occur when homing.  I would like to leave the box unchecked as I believe it will square the gantry as there are limit switches @ both ends of each of the three axis.  All limit switches are wired in parallel and are normally open. 


Offline ger21

  • *
  •  6,293 6,293
    • View Profile
    • The CNC Woodworker
Re: Homing issue with slaved axis
« Reply #1 on: June 04, 2012, 10:09:11 AM »
Make sure both are set to the same homing speed in Config > Homing/Limits

2010 Screenset

JointCAM Dovetail and Box Joint software