Hi Guys,

Although it was my original intention to make this an ‘open source’ project for anyone to construct, commercial interest was shown. They took their time deciding but following a reasonable offer I have now sold the design.

Tweakie.

That's awesome Tweakie!

Hi Guys,

Although it was my original intention to make this an ‘open source’ project for anyone to construct, commercial interest was shown. They took their time deciding but following a reasonable offer I have now sold the design.

Tweakie.

Where can we buy one?

is there an idea when one these would be available to buy?
Frank

I am also very intrested in the plans or to buy a ready built unit.

Can you tell me what transistors you used in your circuit board?
Frank

Hi Guys,

I am really sorry, but I have agreed not to disclose any further details.    (This is the problem when an idea is sold but I just could not refuse the cash).

Tweakie.

You can't even tell us where to buy one???

Would this probe work on a es915 spindle head which is ceramic and requires a  ground magnet attached to the tool collet.
Would like to eliminate the ground wire,

Hey Tweakie....I know this is an old post..but I am tired of alligator cliipping the ground to my router bits!!!! Looking to get a switch type to set my Z height...I know you sold your design, where can I get one?

Thanks
Leslie