Hello Guest it is March 28, 2024, 07:08:34 AM

Author Topic: Screw mapping  (Read 6255 times)

0 Members and 1 Guest are viewing this topic.

Screw mapping
« on: January 05, 2007, 04:54:41 PM »
As I plan on upgrading my X2 by greatly increasing both X & Y travel with leadscrews, I may need to look at mapping the screws. I have looked at the MACH 3 Screwmapping function and understand what it does but am confused on how to use it. Are there any instructions or example of screwmapping available?
Re: Screw mapping
« Reply #1 on: January 06, 2007, 06:24:19 PM »
I have not used that function :(  It was something that was added a long time ago for only a few users... There should be a section in the manual on it :)
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com
Re: Screw mapping
« Reply #2 on: January 08, 2007, 02:59:27 PM »
Brian,
Thank you for the reply, but after re-reading all of the currently posted documentation I am unable to locate Any reference to "Screwmapping" Is there any of the documentation from the time it was added available?
Re: Screw mapping
« Reply #3 on: January 09, 2007, 06:58:03 AM »
Talked to Art and he told me that you need to put the position that the table SHOULD... Hope that helps :(

If you post on the yahoo group there may be a few others over there that can help :) Very sorry I don't know that section....
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com