Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: dsteven1 on January 05, 2007, 04:54:41 PM
-
As I plan on upgrading my X2 by greatly increasing both X & Y travel with leadscrews, I may need to look at mapping the screws. I have looked at the MACH 3 Screwmapping function and understand what it does but am confused on how to use it. Are there any instructions or example of screwmapping available?
-
I have not used that function :( It was something that was added a long time ago for only a few users... There should be a section in the manual on it :)
-
Brian,
Thank you for the reply, but after re-reading all of the currently posted documentation I am unable to locate Any reference to "Screwmapping" Is there any of the documentation from the time it was added available?
-
Talked to Art and he told me that you need to put the position that the table SHOULD... Hope that helps :(
If you post on the yahoo group there may be a few others over there that can help :) Very sorry I don't know that section....