Thanks Hood,
Cut acceleration to 175 and velocity down to 4000mm/min and things running a good bit better. testing out y axis now as I got the calibrated Dial gauge on saturday and had calibrated y before with a non calibrated gauge and vernier calipers. Shaping up much better, x is now spot on after 1000 lines of code run and Y was out by .2mm after the same. which for me needs to be fixed. I cut plastics (Acrylic, HDPE, etc.), Hard and soft woods, and will be getting into brass, bronze in the near future (PB102 to PB105 bronze).
looks like I will be takingthe advice of the man who built it for me and setting up a few profiles to deal with different materials.
Again thanks and progress made, hopefully this will still keep nice tight corners with the system set at CV.
Michael