Hello Guest it is September 23, 2020, 04:43:47 AM

Author Topic: Rotary and linear axis not moving together in automatic mode.  (Read 4801 times)

0 Members and 1 Guest are viewing this topic.

Re: Rotary and linear axis not moving together in automatic mode.
« Reply #10 on: December 30, 2006, 08:30:17 AM »
It will not move at the same time because the movement for the simultaneous is not supported. I am going to look in the code and see if it can be changed
 
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com
Re: Rotary and linear axis not moving together in automatic mode.
« Reply #11 on: December 30, 2006, 10:06:54 AM »
Will be changed in the next release :)
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com