Hi all, I have been pulling my hair out for a few days ever since i tried the spindle calibration test in mach turn. before i ran the calib test my requested rpm and real rpm were about 150 rpm diffrence at some places in the curve and exactly right in others,but since i did the calib test i cant get full rpm and the requested rpm and real rpm are miles out. Is there a way to reset the calib test so its asif i never did it? i did read somewere that deleting the liniearity.dat file will work but i tried it and it made no diffrence. also tried completley uninstalling mach and reinstalled it, saveing only the XML file with all my settings on but even that didnt work.
any advice or suggestions on things i could try to get it back to how it was before i did the spindle calib test will be much appresiated
regards
Simon