I've been playing with the brain part of the software and have a situation: I setup a brain that reads the Y position DRO, so that when the machine is away from the work area and near the tools the dust hood (flood) is up (enabled). Doing this overrides the flood toggle so that the dust hood is either up or down depending on the machine location, is there a way around this so it only locks the dust hood up when it's by the tools but the rest of the machine you can toggle it up or down?
I wanted to setup another one kept the dust hood up if the tool is under a certain length, but I suspect I'll have the same problem. (when using a tool longer then the set length the hood would be stuck down...)
Also whenever I go to brain control and load any brain I get a Bad XML read but they still seem to work....any ideas on that?