Hello Guest it is November 15, 2019, 03:19:53 PM

Author Topic: Can't find mirror image  (Read 2471 times)

0 Members and 1 Guest are viewing this topic.

Offline dresda

*
  •  222 222
    • View Profile
Can't find mirror image
« on: September 25, 2011, 04:49:58 PM »
Does Mach3 have mirror image?
Thanks.

Offline ger21

*
  • *
  •  6,288 6,288
    • View Profile
    • The CNC Woodworker
Re: Can't find mirror image
« Reply #1 on: September 25, 2011, 05:14:34 PM »
Set the scale of the axis you want to mirror to -1.
Gerry

2010 Screenset
http://www.thecncwoodworker.com/2010.html

JointCAM Dovetail and Box Joint software
http://www.g-forcecnc.com/jointcam.html

Offline dresda

*
  •  222 222
    • View Profile
Re: Can't find mirror image
« Reply #2 on: September 25, 2011, 05:40:36 PM »
Thanks very much. Ray.

Offline dresda

*
  •  222 222
    • View Profile
Re: Can't find mirror image
« Reply #3 on: September 25, 2011, 09:58:23 PM »
That did some crazy stuff...... :o

Offline Tweakie.CNC

*
  • *
  •  7,997 7,997
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: Can't find mirror image
« Reply #4 on: September 26, 2011, 02:30:36 AM »
I would set the X Axis Scale DRO  to -1.0000 to produce the mirror image.
What did you do to get "crazy stuff" ??  ;D

Tweakie.
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.

Offline dresda

*
  •  222 222
    • View Profile
Re: Can't find mirror image
« Reply #5 on: September 26, 2011, 09:47:51 PM »
I think i should have selected the mirror image when I was at the g54 x and y zero.