Hello Guest it is September 18, 2019, 09:33:09 PM

Author Topic: THC CIRCUIT  (Read 2318 times)

0 Members and 1 Guest are viewing this topic.

THC CIRCUIT
« on: August 29, 2011, 07:16:45 AM »
Hello everyone. I have long been in this forum but never write.
 I recently built a plasma cutting machine and seems to fit well.
 The problem I have is that I need THC and see are very expensive for me. I'm looking at the circuit of thc leading Mach3's instructions, but do not quite understand.
 Anyone have data on that circuit? or know how it works?
 If so I would make the circuit for my machine: Here I leave a picture of this.

 
« Last Edit: August 29, 2011, 07:43:04 AM by Overloaded »
Re: THC CIRCUIT
« Reply #1 on: August 29, 2011, 12:17:28 PM »
have you checked out the lcthc height controller from candcnc? 249.00 and comes with voltage sensor card. i just purchased and installled. works very well. and the price is reasonable.
Re: THC CIRCUIT
« Reply #2 on: August 29, 2011, 03:37:31 PM »
Super tanks tripleblack.
Now I see the page you say to order one