Hello Guest it is March 28, 2024, 06:42:00 PM

Author Topic: softlimits  (Read 3452 times)

0 Members and 1 Guest are viewing this topic.

softlimits
« on: January 28, 2006, 09:32:30 PM »
I am having a problem using softlimits.

My configuration units are metric.  The X limit is 600 mm.  Softlimits seems to work fine.

If I change units to inches on the setup page softlimits stops the X axis at .93
instead of 23.6 inches.  Softlimits has shrunken my X axis by a factor of 25.4

--slow
Re: softlimits
« Reply #1 on: January 28, 2006, 10:50:04 PM »
Could you check you native units? This is under config system units. It sounds like it is set to inch...
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com

Art

*
Re: softlimits
« Reply #2 on: January 28, 2006, 11:04:06 PM »
Hi:

  This is a known bug. It is recommended that you create a metric and an english profile. USe th eappropriate profile for metric or standard use untill the bug is repaired..

Thnks
Art