Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: slow on January 28, 2006, 09:32:30 PM
-
I am having a problem using softlimits.
My configuration units are metric. The X limit is 600 mm. Softlimits seems to work fine.
If I change units to inches on the setup page softlimits stops the X axis at .93
instead of 23.6 inches. Softlimits has shrunken my X axis by a factor of 25.4
--slow
-
Could you check you native units? This is under config system units. It sounds like it is set to inch...
-
Hi:
This is a known bug. It is recommended that you create a metric and an english profile. USe th eappropriate profile for metric or standard use untill the bug is repaired..
Thnks
Art