Hello Guest it is March 28, 2024, 01:41:47 PM

Author Topic: Microstepping on the driver...  (Read 2434 times)

0 Members and 1 Guest are viewing this topic.

Offline Rikk

*
  •  19 19
    • View Profile
Microstepping on the driver...
« on: August 01, 2011, 12:21:06 PM »
If I change the micro step setting on the driver will I need to redo the steps per in mach3?  if so I assume if I say go from 16 to 8, I could divide the current number by 8 and that would be my new steps per?

Thanks

                 ...........Rikk
Re: Microstepping on the driver...
« Reply #1 on: August 01, 2011, 12:38:09 PM »
yes you will need to change them

Offline ERP

*
  •  35 35
    • View Profile
Re: Microstepping on the driver...
« Reply #2 on: August 01, 2011, 01:06:26 PM »
you would divide by 2 not 8 in that case but yes you will beed to change them

Offline Rikk

*
  •  19 19
    • View Profile
Re: Microstepping on the driver...
« Reply #3 on: August 01, 2011, 01:30:58 PM »
I'll dive in and have a play then, see if this fixes my little issue :)

Thanks