Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Rikk on August 01, 2011, 12:21:06 PM
-
If I change the micro step setting on the driver will I need to redo the steps per in mach3? if so I assume if I say go from 16 to 8, I could divide the current number by 8 and that would be my new steps per?
Thanks
...........Rikk
-
yes you will need to change them
-
you would divide by 2 not 8 in that case but yes you will beed to change them
-
I'll dive in and have a play then, see if this fixes my little issue :)
Thanks