My servos are getting hooked up now.
In accordance with the Gecko manual I have completed checking the encoders.
Now the step & direction process has me stumped.
The Gecko320x is supposed to fault when it receives step signals & the motor armature isn't connected.
Mine won't fault.
I have checked the continuity on the wires with an ohm meter.
The B_o_b is showing that Mach is sending steps through it. ( The B_o_b is a PMDX 126)
The steps aren't reaching the drives somehow.
After searching for fault problems on here, there aren't any problems where the drive "won't fault."
I'm sure it will be stupidly simple when someone points it out.
My encoders ( AMT 103) are set at 500. The Geckos are set at (+/- 256 default) following error.< This setting I don't know enough about to mess with.
The following error settings is something I don't fully understand.
Thanks,
JAckal