hello, i have a little promblem. i am trying to configure my gravitech lcd trought macropumb. here is code that i am using.
cnt=getVar(1000)
if cnt=10 then
setVar(1000, 0)
SendSerial _
"?x00?y0" & "S " + Format (Getdro(17) , "0000.00") + " " & _
"?x00?y1" & "F " + Format (Getdro(18) , "0000.00") & _
"?x00?y3" & "T " + Format (Getdro(24) , "0000") & _
"?x00?y2" & "C " + Format (Getdro(14) , "00:00:00")
else
setVar(1000, cnt+1)
end if
spindle speed, feedrate and tool number is working fine. but i have problem with elapsed time. on lcd is always "00:00:00". i try to write code without 00:00:00 but then is on lcd only "0".
sorry for my bad english