TP, Thank you for your input.
I believe that I tested some of your suggestions, however, I will go back again and retest.
As for the depth, I will go back and reread the manual, however, I thought that it said
that the depth could be specified in either pos/neg value as the program turns it into absolute
value. I have read so much lately that I am forgetting about which feature I read the specifics.
The reason I used the value of 3 for the Pecks was because, as you suggested, at first I also
put an incremental value such as .20, however, then the program comment read something like
(Peck Drill hole, with 0.25 tool 0.6 deep, in .02 steps) and that didn't seem correct to me either.
If this gives you any further insight, please let me know. I will go back and test some more.
Andy