I'm still confused. In section 7 of the current manual (Mach3 SW Integration), sections 7.2 and 7.3 show the mapping of DSPMC pins to Mach 3 I/O. Nowhere is listed the J6 quadrature encoder inputs.
In the screenshot shown on page 34 of the manual, it shows the Mach3 Ports and Pins configuration, with the Input Signals tab selected. At the top of the list is the X++ and X-- inputs. I'm assuming I need to assign those to the J6 encoder pins. But since there is no mapping of the DSPMC J6 connector, I don't know what to put into the table for the encoders.
Do I need to configure these inputs or will the plug-in take care of J6 for me?
I have the same question for teh Encoder/MPGs tab. It lists the 4 encoders, and it wants port and pin numbers to be assigned, but I don't know what to put in there.