Tradução do português para inglês
G91 and other problems.
Please I need help on some issues.
I am using the latest versions of MACH3 XX.43.22 and some earlier and noticed the following.
1. When we work on the G91 there is information that is not possible to stop and return the program REVERSE MODE.OK? Is it possible that someone's day?
2. When in G91 and STOP program for cleaning up a torch or something and made a command "RUN FRON HERE", the axes will move exactly twice the requested coordinates on the line where we start running. Seems to me that the versions of MACH2 did not.
Is that correct?
3. What can I do to my FEED HOLD or PAUSE is faster, ie, immediately stop the axes. I have a long delay until the axle stop.
Attached the gcode I'm working on my Oxycorte.
The deceleration of the axes are between 0.5 sec per axis.
Such cases occur with either the SS or PP.
With DSPMC the problem is:
MPG mode, Software Limits do not work, leaving the axes collide mechanically. Only in this situation.
If someone can help me ..Thanks