If I issue g1 z-1.000 in the mdi the torch moves down. I have set my varible offset at .275 and pierce height at .100 but I don't see them in the code.
Here is the first part of the code.
N0000 (Filename: Roof Rack clamp HWE style scaled up.tap)
N0010 (Post processor: Plasma THC300 - G31.post)
N0020 (Date: 5/8/2011)
N0030 G20 (Units: Inches)
N0040 G53 G90 G40
N0050 F1
N0060 S500
N0070 (Part: Roof Rack clamp HWE style scaled up)
N0080 (Process: Plasma, 0, Plasma, 0.0008 inch kerf)
N0090 M06 T0 (Plasma, 0.0008 inch kerf)
N0100 G00 Z0.1575
N0110 X-0.1600 Y-0.1604
N0120 G31 Z -100 F19.685
N0130 G92 Z0.0
N0140 G00 Z0.0000
N0150 G92 Z0.0
N0160 G00 X-0.1600 Y-0.1604 Z0.1000
N0170 M03
N0180 G02 X0.0000 Y-0.0004 I0.1600 J0.0000 F60.0
N0190 G01 X1.0400
N0200 G03 X1.0404 Y0.0000 I0.0000 J0.0004
N0210 G01 Y3.1200
N0220 G02 X1.9896 Y3.1200 I0.4746 J0.0000
N0230 G01 Y0.0000
N0240 G03 X1.9900 Y-0.0004 I0.0004 J0.0000
N0250 G01 X3.0300
N0260 G03 X3.0304 Y0.0000 I0.0000 J0.0004