Hello Guest it is November 18, 2019, 09:43:10 AM

Author Topic: Motor chatter  (Read 2046 times)

0 Members and 1 Guest are viewing this topic.

Motor chatter
« on: April 24, 2011, 11:25:23 PM »
I am having a hard time getting my motors tuned in. no matter what i do they chatter at low speeds. if i change the tuning so they move faster. they run great. and they will move very fast. but slow. they chatter and stutter and make all kinds of noise.

 Any suggestions??

Offline Tweakie.CNC

*
  • *
  •  8,002 8,002
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: Motor chatter
« Reply #1 on: April 25, 2011, 02:01:16 AM »
Sounds like the good old days ? before microstepping.  :'(

I use 1/8th stepping and that is pretty smooth at low speed but with the later controllers 1/16th stepping is not uncommon now and that is really smooth.
Could this be the problem ?

Tweakie.
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.

Offline RICH

*
  • *
  •  7,371 7,371
    • View Profile
Re: Motor chatter
« Reply #2 on: April 25, 2011, 05:15:59 AM »
What is the make and model of drives you are using?

RICH
Re: Motor chatter
« Reply #3 on: April 25, 2011, 06:33:04 AM »
My motor controller will allow 1/16th microstepping. I currently have it set for full step. tonight I will re-adjust everything at 1/16th and see if i can get the problems to go away.

 The motors are what came with the machine and I can find no Data on them other than whats on the label Shibaura 55230004 30V 2A/Phase 1.8Deg/Step. would love to find a datasheet if anyone has jedi powers to find such things!