Wow, what a difference
I exploded the lines and saved the dwg in R12 and now LC shows a perfect drawing. Thank you
BTW Gerry I dont have any “regular splines” in my Acad. Under the Draw Menu among other shapes I only have “Spline” or normally I type at the command “spline”. I only have Acad V14, perhaps regular splines are only available in newer / older versions?
However the text is not shown in LC properly. I tried to use different fonts in Acad but LC does not import the fonts properly. Then I removed the text from my dxf and I tried in LC to stick at the bottom part of my dwg my text with the Text menu from LC. That didn’t work either because my drawing almost disappeared,
Is there any trick to get some text in LC on a dwg that I import into LC?