I can not post this lazycam file to G-code. I click on "ok" on posting table, but my G-code is not created.
I have try other lazycam file, and they works. In this case, I fine that after I use "OFFSET" function to create a  shape, the whole can not be posted...? Any one could help me? Thank you very much, because I am counting on it to make a subject for my project.
I attached the original DXF file and the lazycam file I can not post.

chennan

Offset is only available in the licensed version of LC.
Do you have your licence file installed correctly ?

Tweakie.

Thank you. I do not have a license...

Chennan, Do you want someone to produce the g.code for the project for you.  Or, would that be considered bad form?

Bob@BobsShop