Hi all,
I found the answer a while ago whilst browsing the forum but now cant for the life of me find the post.
Im up and running now and have gone through the motor tuning and calibration. I found the maximum smooth motor velocity for eaxch axis and then knocked a bit off for safety. Whilst I can get to high speeds, the motor sounds rough. At the moment the maximum I am able to get is about 800mm/min. I will be mainly cutting mdf, plywood, hdpe and some aluminium. The machine is small and uses a proxxon (like a dremel) so only small bits. Is this speed ok? I know the feedrate varies depending on the material, tool, etc but from looking at videos on youtibe mine seems quite slow and whilst a few test cuts have been sort of ok, I want to get the machine and software set right before I start going any further.
Thanks