Hello Guest it is May 23, 2025, 12:20:58 PM
Profile Guest
« previous next »
Pages: « 1 2 3 4 5   Go Down

Author Topic: M03 macro and changing pulleys  (Read 36095 times)

0 Members and 2 Guests are viewing this topic.

Offline Aeroshade

*
  • 141 141
Re: M03 macro and changing pulleys
« Reply #40 on: April 15, 2011, 08:26:33 PM »
I'm not calling a macro from the program. Mach3 reads M3 and SpindleSpeed on it's own. You can test it by putting a message in your SpindleSpeed macro and it will show when you run the M3 macro (AKA M03S100)


Aero
Logged

Offline BR549

*
  • 6,965 6,965
Re: M03 macro and changing pulleys
« Reply #41 on: April 16, 2011, 07:45:51 PM »
OK I go what you are doing(;-) I was hopping between projects and was not paying attention to detail.

I'll test it here later tonight.

(;-)TP
Logged
Pages: « 1 2 3 4 5   Go Up
« previous next »