Hello Guest it is March 29, 2024, 02:17:04 AM

Author Topic: M03 macro and changing pulleys  (Read 20090 times)

0 Members and 1 Guest are viewing this topic.

Re: M03 macro and changing pulleys
« Reply #40 on: April 15, 2011, 08:26:33 PM »
I'm not calling a macro from the program. Mach3 reads M3 and SpindleSpeed on it's own. You can test it by putting a message in your SpindleSpeed macro and it will show when you run the M3 macro (AKA M03S100)


Aero

Offline BR549

*
  •  6,965 6,965
    • View Profile
Re: M03 macro and changing pulleys
« Reply #41 on: April 16, 2011, 07:45:51 PM »
OK I go what you are doing(;-) I was hopping between projects and was not paying attention to detail.

I'll test it here later tonight.

(;-)TP