HI, I'm having an issue with my E-stop. I can reset it (in the software) but it immediately comes back on. I have restarted my CPU, tried messing with the physical E-stop but to no avail. I'm new at this CNC thing so this is really slowing down my learning process since I cannot even get my machine to jog etc. while it is in the E-stop mode.
Any advice would be greatly appreciated.

Sounds like you are getting electrical noise on the E-Stop signal, best to shield the wires properly if that is the problem but setting a debouce interval of 2000 might mask the issue until you can do that. You will find it from Config menu then General Config.
Hood