Hello Guest it is March 29, 2024, 05:53:14 AM

Author Topic: Milling parts from end of stock  (Read 12163 times)

0 Members and 2 Guests are viewing this topic.

Offline BR549

*
  •  6,965 6,965
    • View Profile
Re: Milling parts from end of stock
« Reply #30 on: January 01, 2011, 05:31:29 PM »
HHS for that app I would use 500 rpm and feedrate of 10 IMP doc .050" then set FRO to 50% adjust from there. Lots of coolant if a avaliable. Monitor chip load and chip color.  Even cuting with 1/4" bit not a problem IF your cut paramaters are correct.

(;-) TP