Is this the way to do it?


test.nc
G01 X2 Y0 M101
G01 X9 M101
G01 X14 M101
G01 X15 Y5 M101
G01 X0  Y4 M101
G01 X1 M101
..............   So on..........

M101.m1s
While IsMoving()
  Sleep 10
Wend

   Code “G1 A2.5”
   Code “G1 A0”
   Code “G1 A1.7”
' 101 is dun

5ms

I guess so...! See a reply to my post about macro's not being executed in written order, though.

You could use a subroutine right in your G-code.  I don't do it enough to write one from memory, but it's not difficult.  

Not heard of a gcode subroutine; would that allow, for instance, 2 commands for an axis on the same line?

You could use a subroutine right in your G-code.  I don't do it enough to write one from memory, but it's not difficult. 

something like:

test.nc
Sub run101()
While IsMoving()
  Sleep 10
Wend

   Code “G1 A2.5”
   Code “G1 A0”
   Code “G1 A1.7”
end sub

G01 X2 Y0 run101
G01 X9 run101
G01 X14 run101
G01 X15 Y5 run101
G01 X0  Y4 run101
G01 X1 run101

You can use a subroutine right in the G code, like this:

test.nc
G01 X2 Y0
M98 P101
G01 X9
M98 P101
G01 X14
M98 P101
G01 X15 Y5
M98 P101
G01 X0  Y4
M98 P101
G01 X1
M98 P101
M30

O101
G1 A2.5
G1 A0
G1 A1.7
M99

Read the manual for more details.

Dan

moorea21, rrc1962 and Dan

Thank you for your replys and your time